-
5 pinch bucles help make securing the user easier and getting out of it a snap
-
Made from nylon with 1" nylon straps with grommets at the end for additional strength
-
Padded center sections provide added comfort
-
Installs easily to most chairs
-
Available in three sizes: small, medium, & large (specify when ordering)
-
Sold as each
Thiis 4 point positioning belt can be used on the upper torso or the abdomen area depending on the needs of the user. You can also use it in conjuction with a seat belt.
Installation Instructions:*
-
Sit the user down in the chair and dry fit the positioning belt to see which holes will work best (make sure the center pinch buckle is facing outward).
-
Remove user from chair.
-
Remove the top screw holding the seat back fabric and insert the strap (the one with one eyelet) eyelet between the fabric and the seat back cane, then reinsert the screw and tighten as before.
-
Remove the bottom screw and insert the strap eyelet (use the one decided on during the dry fit proccess) and tighten as before.
-
Repeat the other side.
-
Return the user to the chair and secure the user. You will need to adjust all 4 straps initially which can take some time for a comfortable fit
* This positioning belt works best with a wheelchair back attached with screws. If your seat back does not have screws in the locations you desire, you may have to drill new holes (both into the seat cane and through the fabric). Modifying your chair with new holes should only be done by a qualified professional and may void its warranty.
This positioning belt is not a safety device. It is to be used only for positioning. It must be used in conjunction with a seat belt. NEVER use this harness as a restraint in a motor vehicle. Use in conjunction with an approved automotive restraint.
Wheelchair 4 Point Positioning Belt
SB340, SB343, SB345 |
