7/16 x 1 1/4 in. Flanged Wheelchair or Scooter Bearing
Maintenance free design and pre-greased
Reference number not available
Inside diameter (bore) 7/16"
Outside diameter 1 1/4"
Outside diameter including flange 1 3/8"
Width (thickness) 3/8"
Sold individually (each)
7/16 x 1 1/4 in. Flanged Wheelchair or Scooter Bearing Fitment Notes
This bearing is commonly found on the rear wheel of some wheelchairs that use flanged bearings. The flange is what holds it in place. Many Everest and Jennings wheelchairs use this bearing on the rear wheels but not all of them. Since there are no reference numbers, you'll want to verify your size using the guide below.
This 7/16 x 1 1/4 in. Flanged Wheelchair or Scooter Bearing can be used as a replacement for the following manufacturer part numbers:
TAGRP155003PK
General Wheelchair and Scooter Bearing Notes
Many bearings found on wheelchairs and scooters have a alpha numeric reference or just a numeric reference number stamped on the side of the bearing which refers to the type and size of the bearing. In most cases, that is all you need to purchase the correct bearing. For alpha numeric reference numbers ending in Z, ZZ, RS, or 2RS, they are all interchangeable (Z and ZZ refer to a metal outer side shield and RS and 2RS refer to a rubber outer side shield protecting the balls inside the bearing). If your bearing has no reference on it, you will have to measure. If the bearing reference appears worn off, you may be able to see it stamped on the other side.
7/16 x 1 1/4 in. Flanged Wheelchair or Scooter Bearing
WARNING: Many of the products carried by EnableYourLife.com can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
