8 x 1 1/4 in. Primo Hollow Spoke Pneumatic Wheelchair Caster Wheel
The 8 x 1 1/4 in. Primo Hollow Spoke Pneumatic Wheelchair Caster Wheel features a multi-rib tread providing a smooth comfortable ride and the three hollow spoke design adds a little flare to your wheelchair. Sold individually (each). For a pair, please order a quantity of 2
Sold individually (each). For a pair, please order a quantity of 2
This wheelchair caster assembly will replace 8 x 1, 8 x 1/4, and 8 x 1 1/2 inch caster wheels found on Quickie, Top End (Invacare), Colours, and many other wheelchair brands. Some TiLite wheelchairs use 3/8" ID bearings and these caster wheels will not work. Regardless of wheelchair brand or caster you have, it is always advisable to confirm your size using the guide below to help you measure your existing caster. Also used as a replacement for Sunrise Quickie 400212.
This 8 x 1 1/4 in. Primo Hollow Spoke Pneumatic Wheelchair Caster Wheel can be used as a replacement for the following manufacturer part numbers:
Sunrise / Quickie 400212
Ki Mobility 100524
Measuring your existing wheelchair caster:
Purchasing the proper wheelchair caster is as simple as measuring the old one. Even if the size is written on the existing caster, you still want to make sure the hub width and bearing size will be correct. Properly measuring will ensure you order the correct caster and prevent an installation headache and the hassle of sending them back.
smooth rolling, February 28, 2013 By john wier (san diego, CA)
used the pneumatic tired wheel on 3 wheeler to replace hard plastic front wheel. Now the 3 wheeler easily rolls over sidewalk cracks and small gravel on paths. No balance threatening abrupt stops on hitting a crack.
WARNING: Many of the products carried by EnableYourLife.com can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.